|
Floor
model Our Floor Model Inserter is a heavy duty spiral binding
inserter of plastic and wire spirals. The Floor Model Inserter
is suitable for inserting all our available diameters.
INSERTER
TYPE:
Roller Inserter
24" Rollers
DRIVE
MECHANISM:
Dual motor drive (for all sizes)
Continuos duty safety stall-out
110v single phase
72 DBA
UL approved
"CUT
AND TURN" PLIERS:
Foot activated
Heavy Duty custom machined heads
"Cut and Turn" even heavy wire in a single motion
Can "Cut and Turn" lighter material simultaneously
OVERALL
MACHINE DIMENSIONS:
42" deep x 42" wide x 44" high
Shipping Weight: 350
SPIRAL
DIAMETER AND MATERIAL WEIGHT:
Can insert all of our available spiral diameters
Pel plastic spirals range up to 3" and Pel wire spirals
up to 3 1/4"
Rod diameter (or weight) for plastic spirals range up to
.145" and for wire spirals up to .094" (nylon coated wire)
INSERTING
SPEED:
Manual start of coil (1 person)
Book thickness: n 1/4" - 9/16", approximately 250 - 350
/ hr. n 5/8" - 7/8", approximately 200 - 250 / hr. n 1" and
up, approximately 125 - 175 / hr.
OPTIONS:
Small diameter spiral guides available for consistent cut
and turn of No. 4 and No. 5 hole spacing
SET
UP:
1. Adjust idler the roller spacing opening to equal slightly
less than the thickness of your book.
2. Wind spiral into the first three to four holes on right
side of your book.
3. Rest book on idler roller with slight pressure against
drive roller, sweeping to the right, allowing spiral to
roll through.
3200 Kashiwa Street
Torrance, CA. 90505 (USA)
Web site: http://www.pel-spiral.com E-mail: info@pel-spiral.com
Telephone: 1.800.531.7145
Fax: 1.310.530.9276
Outside the United States dial:
1.310.530.7145
Business hours:
7:00 A.M. - 3:30 P.M.,
P.S.T Monday-Friday
This
site is best when viewed with your monitor's resolution set at 800 x 600 and a minimum
of thousands of colors.
Created and maintained by GuerrillaAd.com