Our Table Top Inserter is designed for plastic and wire spiral binding. The Table Top Inserter is suitable for inserting all of our available spiral binding diameters.

INSERTER TYPE:
Roller Inserter
24" Rollers

"CUT AND TURN" PLIERS:
Specially designed "needle nose" type pliers recommended for lighter weight plastics. (Heavy Duty "Cut and Turn" Pliers are also available.)

DRIVE MECHANISM:
Dual motor drive (for all sizes)
Continuos duty safety stall-out
110v single phase
72 DBA
UL approved

SPIRAL DIAMETER AND MATERIAL WEIGHT:
Can insert all of our available spiral diameters
Pel plastic spirals range up to 3" and Pel wire spirals up to 3 1/4"
Rod diameter (or weight) for plastic spirals range up to .145" and for wire spirals up to .094" (nylon coated wire)

INSERTING SPEED:
Manual start of coil (1 person)
Book thickness: n 1/4" - 9/16", approximately 250 - 350 / hr. n 5/8" - 7/8", approximately 200 - 250 / hr. n 1" and up, approximately 125 - 175 / hr.

OVERALL MACHINE DIMENSIONS:
21" deep x 29" wide x 8" high
Shipping Weight: 55

SET UP:
1. Adjust idler the roller spacing opening to equal slightly less than the thickness of your book.
2. Wind spiral into the first three to four holes on right side of your book.
3. Rest book on idler roller with slight pressure against drive roller, sweeping to the right, allowing spiral to roll through.